Effect Of Melting Point Of Polyethylene Wax On Road Marking Paint

The impact of the melting point of polyethylene wax on road marking paint. During the construction process of hot-melt road markings, this product can shorten the tire-free time of the paint and improve traffic efficiency. After the paint is cured, an anti-fouling layer is formed on the surface. Keep the markings clean and natural.

1. Polyethylene wax is widely used in road marking paint and is used in hot melt road marking paint. Its main functions are dispersant and leveling agent.
2. When using polyethylene wax for road marking paint, it must not contain any paraffin wax or add calcium powder, and it must be pure.
3. The melting point is also required to be higher than 100 degrees. Some manufacturers of road marking paint require the melting point to be above 110. If it is too low, it will cause the road markings to become soft, blistered, cracked, and not resistant to stains. .
4. The amount of oil should also be small or even oil-free; at the same time, the drying should be fast, the adhesion should be strong, and the processing temperature should be above 180 degrees.

Requirements for wax used in road marking paint: The polyethylene wax has good flow properties, giving the product high flow properties and is easier to construct; it has better heat resistance and high hardness, making the paint surface hard and resistant. Scratch resistance, rolling resistance, temperature resistance; good wetting and dispersion effect on titanium dioxide powder; good external slippery properties, making the paint film good at anti-fouling ability!