Application of wax emulsion on yarn post-treatment

After dyeing or pretreatment, the wax and greasy substances on the surface of cylinder yarn will be damaged, making the yarn dry and astringent, increasing the friction coefficient and hardening the feel.

Wax emulsion OE-6301 is especially suitable for cotton cylinder yarn finishing, after finishing, the fabric has good softness and smoothness, and good uniformity of inner, middle and outer layers.

Wax emulsion use effect
1, The cylinder yarn treated with wax emulsion OE-6301 increases the smoothness of the yarn, thus improving the friction resistance between yarn and yarn, yarn and yarn guide parts during weaving, reducing the head breakage during winding and weaving, and improving the working efficiency.

2, After treated with wax emulsion OE-6301, the cylinder yarn can be evenly adsorbed on the whole surface of the yarn, so that the yarn has good uniformity in the inner, middle and outer layers and is less likely to break during weaving.

　Product properties
1, Gives cotton cylinder yarn a smoother and fluffy soft hand feel.

2, Low yellowing, very suitable for finishing white/light colored fabrics.

3, Self-dispersing property, no need for emulsifier, easy to use and cost saving.

4, Reduces yarn friction resistance and head breakage.

5, Excellent stability, can be used under different finishing conditions.

6, Suitable for dipping and spraying process, wide range of application.

　　Notes on the product of warp wax emulsion for cylinder yarn
1, Textile residual alkali and instability and water pH value will affect the finishing effect, must be cleaned before finishing.

2, Textile residual alkali and instability and water pH value will affect the finishing effect, must be cleaned before finishing.

3, The water used in the working fluid should be ≤ 200ppm tap water, with groundwater or river water should be treated before use.

4, Pay attention to observe the use of rolling trough: when there are more hair, pay attention to change the material to clean the rolling trough.

5, This product is a weak cationic product, if you use paint, adhesives and other anionic products in the chemical tank, you need to clean it before chemical material.

6, Although the softener emulsion is compatible with most cationic and non-ionic additives, but for the sake of safety, it must be tested for compatibility before mixing. The stability of emulsions can also be affected under extreme conditions.